- Should fence posts be inside or outside?
- Is it better to nail or screw fence boards?
- Will wooden posts rot in concrete?
- Is 2 feet deep enough for fence posts?
- How many bags of concrete do I need for a fence post?
- How do you attach a fence to a brick house?
- How close can a fence post be to a house?
- Can a fence be attached to a house?
- How many gates should a fence have?
Should fence posts be inside or outside?
Fence posts should be on the outside of the fence The correct installation of ag fencing is to place it on the inside of the posts.
This way, animals in the enclosure brush against the wire, not the posts.
Fence posts that have been placed outside of the fence material will take nearly all of the animal’s force..
Is it better to nail or screw fence boards?
In addition, screws are typically more expensive than using nails. In the end, though, screws are more effective and last longer. Even better, it is much simpler and efficient to remove screws holding a fence together to make repairs or to replace a few boards than to try to pull out nails and make adjustments.
Will wooden posts rot in concrete?
Simply setting the posts in concrete does create a condition that will accelerate rot in the bottom of the posts. With pressure-treated posts, the rot will be slow. … First, the posts should be set on top of a bed of coarse gravel 3 to 6 inches deep, so the base of the post is in contact with the gravel.
Is 2 feet deep enough for fence posts?
The minimum depth that you should dig your fence post holes for panel sections is 2 feet. A general formula is to dig the holes one-third to one-half of the post’s aboveground height. The deeper you dig the holes, the more stability your fence has, but you must also purchase longer posts.
How many bags of concrete do I need for a fence post?
Mix two 50lb bags of concrete with water in a mixing tub or 5-gallon bucket. Add concrete into the hole and around the 4” x 4”. Depending on your climate, let concrete set up for 24 – 48 hours.
How do you attach a fence to a brick house?
You cannot secure fence hinges to brick with simple screws and expect them to hold. In fact, you will likely never get the screws to stay in the bricks. The best way to secure a fence gate to a brick wall is by installing anchor bolts, using a hammer drill equipped with a masonry bit.
How close can a fence post be to a house?
While the post positioning will vary depending on the fence panel width you choose—i.e. if you have 6-foot-wide panels, you’ll need to put a post every 6 feet—regardless of the panel length, you should always start with the post that’s closest to your house.
Can a fence be attached to a house?
Don’t attach the fence to the house. Aside from putting holes in your siding (not a good thing), your fence and your house will most likely move differentially. The attachment could result in a tear of the siding, which would be a bad thing.
How many gates should a fence have?
When planning out gate entrances, make sure to include at least two gate entrances and make one of those entrances slightly wider to accommodate bulky equipment. A 3-foot wide gate entrance will easily accommodate pedestrians, but a wider entrance is needed for items such as trash bins, lawn mowers and wheelbarrows.